Компания ГлавМорСнаб - General Maritime Supply - судовое снабжение


English version »
Судовое снабжение - Качественный СЕРВИС
Каталог снабжения
   
Услуги
Услуги
   
Производство
Производство
   
Фотогалерея
Фотогалерея





Снабжение | Масла ВР | ENERGOL HV Hydraulic Oils

Масла ВР

Energol HV Energol HV is a range of high performance, zinc free hydraulic oils.
Application Energol HV is a range of oils designed for general use in hydraulic systems including critical high pressure systems such as those used for cargo handling. For very low temperature operation and the requirements of control systems with long small bore pipe-runs, please refer to the data sheet entitled -Special Hydraulic Oil.
Main Performance Features
  • Excellent filterability even in the presence of water.
  • High viscosity index (VI) permits operation over a wide range of temperatures and limits peak system pressures under 'cold starting'.
  • Compatible with all metals normally used in hydraulic systems - including silver.
  • Good anti-wear properties give very low rates of wear in pumps and motors.
  • High oxidation stability ensuring long oil life.
  • Rust inhibited to provide protection in pipework and equipment internals.
Approvals Approved by, or meets the specification requirements of, major hydraulic pump, valve and motor manufacturers. A 52 cSt. grade is approved for Framo initial fill.
Care and Handling When commissioning a hydraulic system it is important that the system is free from any water, rust, and any other deleterious material such as corrosion protective. It is recommended that the system is thoroughly flushed before filling with the operating charge. Equipment manufacturers' recommendations with respect to filtration and oil change intervals should be followed. To minimize the risk of contamination it is recommended that all hydraulic oils should be filtered into the system.
Packaging and Storage Supplied in bulk or in drums of approximately 210 liters. Where outdoor storage is unavoidable, drums should be covered. The drums should be stored in such a way as to ensure they are not damaged and grade markings not obliterated; position them horizontally so as to prevent water collecting on drum ends. Ensure drums are tightly re-sealed after use.
Typical Characteristics
Test Method Units 15 22 32 46 68 100 150
Kinematics Viscosity 400C ASTM D445 mm2 s-1 15 22 32 46 68 100 150
Density 150C ASTM D1298 kg/m3 860 860 870 880 880 890 890
Flash Point (PMC) ASTM D93 0C 146 158 190 198 188196 190
Viscosity Index 0 ASTM D227 152 155 153 152 142133 128
Pour point ASTM D97 0C -51 -42 -39-36-39-33-30

The above figures are typical of those obtained with normal production tolerances, and do not constitute a specification. Note 1 mm2 s-1 = 1 cSt.
Health, Safety and Environment Health, safety and environmental information is provided for this product in the Material Safety Data Sheet. This gives details of potential hazards, precautions and First Aid measures, together with environmental effects and disposal of used products. The British Petroleum Company plc or its subsidiaries will not accept liability if the product is used other than in the manner or with the precautions or for the purpose/s specified. Before the product is used other than as directed, advice should be obtained from the local BP office.

Copyright BP Oil International Ltd.

Логотип ГлавМорСнаб г. Новороссийск
тел.: +7 (8617) 648-150
тел.: +7 (8617) 648-160
e-mail: GMSupply@nvr.ru
Создано:
IDALGO
ARTMODEL
Все права защищены и охраняются законом.
© 2003 - 2021 г.